Coherent FieldMaxII-TOP Instrukcja Użytkownika Pobierz pdf (Strona 50)

FieldMaxII-TOP User Manual

Avg

Average mode enables display smoothing, which

suppresses variations in the display reading that can

make it difficult to read.

Display values are averaged either by time (for ther-

mopile or optical sensors), or by pulses (for pyroelec-

tric sensors).

You can change the size of the display smoothing

window. With an attached thermopile or optical sensor,

the window size is 1 to 60 seconds. Using a pyroelectric

sensor, the window size is 2 to 1,000 pulses.

The Avg button is used to:

• Toggle the state of Average mode (if the button is

pressed for less than one second).

• Enter Edit mode and select the display smoothing

window size (if Setup/Local is pressed before-

hand).

• View the display smoothing window size (if the

button is pressed for one second or more).

Atten

Attenuation mode allows you to get true measurements

using an attenuator that has a known attenuation factor.

When Attenuation Correction mode is enabled, the

measured value is adjusted to indicate the measurement

at the attenuator and not the sensor. The range for this

mode is 0.01 to 999.99.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 117 118

Brak uwag

Coherent FieldMaxII-TOP Instrukcja Użytkownika Strona 50